QSC Audio CXD4.5, CXD4.2, CXD4.3 manual Home Presets Preset Wizard Enter, Output

Preset Wizard

NOTE: The power levels shown in this procedure are taken from the CXD4.3 unless indicated otherwise. CXD4.2 will show less power and CXD4.5 will show greater power. For complete details refer to the "Specifications" on page 28.

HOME > PRESETS > PRESET WIZARD > ENTER

Step 1 — Adjust Impedance and Power

OUTPUTS		SPEAKERS		SAVE	Adjust Impedance based on
Output:	A	B	C	D	the total loudspeaker load
					connected to the channel.

Imped:	8.0	- -	- -	- -	Default = 8 Ω
Power:	625	- -	- -	- -	Default = min. for amp

Remaining Power Available: 1875 W	Impedance and Power
	are dynamically linked
Enter Load Profile (Impedance and Power)	for adjustments.

Scroll to select (Imped or Power)

To edit, press

Turn to adjust parameter

To confirm, press

Repeat for remaining output channels

ENTER

ENTER

EN	Possible Output Mode Combinations using the Preset Wizard
		A	B	C	D	AB	C	D	AB	CD	A+B	C	D	A+B C+D		ABC	D	AB + CD	ABCD
		- - -	- - -	- - -	- - -	- - -	- - -	- - -	- - -	- - -	- - -	- - -	- - -	- - -	- - -	- - -	- - -	- - -	- - -
	*
		25%	25%	25%	25%	50%	25%	25%	50%	50%	50%	25%	25%	50%	50%	75%	25%	100%	100%

Modes: A B = Separate Channels / A+B = Bridge Mode / AB = Parallel Mode

*Precentages are used to represent the power for different amplifier models.

—Figure 25 —

Step 2 — Select Output Channel for Speaker Assignment

OUTPUTS SPEAKERS SAVE

Output: A B C D

Imped: 8.0 8.0 8.0 8.0

Power: 625 625 625 625

Spkr: - - - - - - - - - - - - - - - -

Assign Assign Assign Assign

When you are finished setting the Impedance and Power for each output, continue to scroll to access the SPEAKERS tab.

Loudspeaker assignment is optional, you can assign a loudspeaker to one or more channels, or none at all.

Scroll to select Output channel

To Assign a loudspeaker, press	ENTER
Continue to Step 3.

Step 3 — Select Speaker Type for Channel

OUTPUTS		SPEAKERS		SAVE		To edit Speaker, press
	Output:		A		Band and Filter	Scroll to select a Speaker model
					selections are based on
Speaker:		WL2102 BiLFNS			the Speaker you select.	To confirm, press
					You must select a	Scroll to select (Band, Filter)
Band:		2-Way LF			loudspeaker before
					selecting Band and Filter.
Filter:		80 Hz				To edit, press
		ASSIGN				Turn to adjust parameter
						To confirm, press
						Scroll to select ASSIGN
					To assign the speaker to the output channel, press

ENTER

ENTER

ENTER

ENTER

ENTER

TD-000367-00-A 16