Castile Pellet Stove
7Appliance Set-Up
A. Outside Air Kit Instructions
Parts Included in Kit: 1 piece of 2 inch x 3 foot flex hose, 2 hose clamps, 1 collar assembly,1 termination cap assem- bly, 1 trim ring, 12 screws.
Tools Needed: Phillips headscrewdriver; wire cutters; hole saw or jig saw.
1.Figure 17.1 shows bottom of convection blower mount and pre-cut air vent opening for reference only. Air channel should be mounted with stove in upright posi-
2.Align hooks in air channel with slots in convection blower mount and ash box, Figure 17.2. Push up and slide forward.
3.Secure air channel to appliance with 2 screws and secure the collar assembly to the air channel with 2 screws. Figure 17.3.
Mounting Slots
R
CAUTION
Never draw outside combustion air from:
•Wall, floor or ceiling cavity
•Enclosed space such as an attic or garage
1.Measure distance from floor to air vent opening in appli- ance and mark location on wall.
Use saw to cut opening in wall. Cut a
2.Use hose clamp to secure flex pipe to collar assembly.
3.Slide trim ring over flex pipe and run pipe through wall.
4.Attach hose to outside termination cap with second hose clamp.
5.Secure termination cap to outside surface.
6.Secure trim ring to interior wall.
Termination
Cap Assembly
Figure 17.1
Hose Clamp
Align hooks with slots, push up
and slide forward
Figure 17.2
Attach air channel to stove with 2 screws
Attach collar to air channel with 2 screws
Figure 17.3
Trim Ring 
Flex Hose
Hose Clamp
Collar Assembly
Figure 17.4
October 11,, 2005 | Page 17 |
