Quadra-Fire CB1200 CB 1200 Pellet Stove Brick Set Installation, Brick Clip Installation

R

CB 1200 Pellet Stove

D. Brick Set Installation

1.Remove the baffle first, follow instructions on page 32.

2.Slide bottom of left rear brick in first; rotate top edge toward rear of appliance and then rotate outer edge toward rear of appliance, until brick slides into place.

Figure 19.1.

3.Repeat with right rear brick.

4.Place left side brick along left side of firebox, making sure chamfered (beveled) back edge of brick fits snugly next to rear brick. Figure 19.2.

5.Repeat with right side panel.

6.Complete brick set, correctly installed. Figure 19.3.

1

Figure 19.1

E. Brick Clip Installation

WARNING

Risk of Injury.

•Brick may have small wires protruding from the back of brick.

1.After the brick set has been installed, 2 brick clips need to be installed on the outer edge of each baffle to hold the brick set in place.

2.Remove 2 baffles from the appliance. Slide the baffle up and the bottom edge should fall down and then lift the baffle out.

3.Using pliers, bend the brick clip slightly past 90° in the direction shown in Figure 19.4.

4.Position the brick clip as shown in Figure 19.4 and use pliers to crimp around the outside edge of the baffle as shown in Figure 19.5.

Note: Figure 19.5 shows the finished shape of the brick clip, after being bent around the outside edge of the baffle.

5.Slide the baffle back into place making sure that the brick clip holds the side brick toward the wall of the firebox. Push back on the sides so they will keep the rear bricks in place. Repeat for opposite side.

 1 2

Figure 19.2

	4
1	2

Figure 19.3

	Approximately
	1 inch from corner
	Outside edge
	of Baffle
Top outside	Use pliers to crimp
corner of Baffle
	Brick Clip around edge

Figure 19.4

Installed Clip

Figure 19.5

September 21, 2006 7014-082B Page 19