Quadra-Fire CB1200 owner manual G. Glass Replacement, CB 1200 Pellet Stove, 4screws

R

CB 1200 Pellet Stove

G. Glass Replacement

WARNING

•Glass is 5mm thick high temperature heat- resistant ceramic glass.

•DO NOT REPLACE with any other material.

•Alternate material may shatter and cause injury.

•Remove door from appliance and place face down on a protected surface to avoid scratching the door.

•Remove all door rope.

Replacing Center Glass

NOTE: DO NOT LET Air Wash Spacers fall down from top frame when removing and replacing center glass.

1.Using a nut driver remove the (5) bottom nuts and remove the bottom glass frame. Figure 33.2.

2.Slightly bend up and out of the way the 2 center posts and slide the glass out the bottom.

3.Slide new glass in, reposition the 2 center posts and re-install bottom glass frame.

4.Re-rope the door.

Replacing Side Glass

NOTE: When removing the side glass with the door latch, you must remove the door latch first before removing the side frame. Use a pow- ered Phillips head screw driver to remove the

4screws.

1.Remove side glass frame.

2.Loosen the top and bottom frame and slightly bend up and out of the way.

3.Slide glass out the side and slide new glass in.

4.Re-install the side glass frame and tighten the top and bottom frames.

5.Re-install the door latch, if applicable, and re-rope the door.

	Door Latch
Top & Bottom Frame
Center Posts
Glass	Side
	Frame

Figure 33.1

Remove Door Latch First

and then Side Frame

Door Frame shown with no Glass or Glass Frames

Remove 5 nuts from Bottom Frame

Figure 33.2

September 21, 2006 7014-082B Page 33