Programming Transmitter to Power Head Unit
Note: Do not press any button on the Transmitter until instructed
1.Press the PROGRAM Switch button located on the garage door power head unit once. The red PROGRAM STATUS light on the motor power head unit and overhead lamp will turn on and remain lit for one minute, indicating that it is ready to learn the Transmitter.
2.Press the button on the Transmitter you wish to use to operate the door. The PROGRAM STATUS light on the power head will turn on and off three times indicating a successful learn.
3.Press the same button on the Transmitter once more to confirm operation. The opener will turn on and move the door.
At this point you will be able to activate the opener.
Battery: If the LED (light) on Transmitter does not turn on when a button is pressed, repeat “changing the transmitter code” opera-
tion. If LED fails to light replace battery. To change battery, insert a coin in the coin slot and twist coin to access battery compartment. Some transmitters use two CR2016 or equivalent batteries while others use a single MN21 or equivalent battery. Snap case together after replacing.
Step 25: Connecting Cushion Arm to Trolley
Activate opener to bring trolley to factory
Cushion arm assembly consists of the door arm tube section and door arm rod, which are packed sepa- rately. To assemble, screw the door arm rod into the door arm tube in a clockwise direction approximately ten turns.
Connect cushion arm assembly into trolley with open end of rod hook facing motor.
Attach warning tag and red pull knob to red release cord connected to trolley.
Step 26: Setting Trolley Close Position
Activate opener to confirm trolley close position is 9” to 10” between the inside face of the door and the solid cushion arm rod. If adjustment of the trolley position is necessary, use the CLOSE TRAVEL ADJUSTMENT knob located on the bottom of the motor power head unit. A 1/4 turn equals approximately 1” of trolley movement; turn clockwise to move forward; counter- clockwise to move back.
17
