Quantum 3214, 3314, 3414, 3316 user manual Install Entrapment Warning Label

Step 9: Installing Deluxe Wireless Wall Station (if included)

Install all wall controls out of the reach of children and in a location where the door can be seen before activating. Do not mount push buttons near or next to ga- rage door.

Locate a convenient place to mount wall station. To keep wall sta- tion out of the reach of children, measure at least five feet up from the floor and secure wall station base into wood wall framing using

(2)Phillips head screws. Pilot drill mounting holes using a 3/32" bit. Use 2 of 3 holes that best align with wood framing.

CAUTION: Over tightening the screws could deform plastic base and interfere with circuit board snaps.

NOTE: Insert bottom of circuit board behind bottom snap of wall station base. Pivot circuit board up until board snaps into place. For best results, press on circuit board between battery terminals.

Insert battery onto circuit board being careful to match (+) positive battery marking with (+) circuit board marking. Align wall station cover/button assembly with base. Press cover assembly over base until cover snaps into place. A uniform seam between the cover and base indicates a proper installation.

Step 10: Install Entrapment Warning Label

Install Entrapment Warning Label next to wall station in a prominent location

Install Entrapment Warning Label next to Wall Station as illustrated. If label adhesive will not adhere to the sur- face, secure the label by additional mechanical means such as staples, nails or screws.

Step 11: Install Wireless Infrared Safety Sensor Quick-Install (QI) Mounting Bracket. (If Opener is Equipped with Wired Infrared Safety Sensor Go to Step 15)

Use the following instructions if your door tracks come pre-punched for using QUICK-INSTALL brackets otherwise go to step 12.

Each bracket is marked either L or R just below the slide lock. (L & R refers to left and right side of ga- rage door as viewed from inside the garage).

Start with the right side bracket as illustrated. Slip the Slide Lock tab of the QI bracket into the door track mounting slot near the bottom of the door track. Slide the bracket downward until it seats at the bottom of the slot. Repeat the same step for the left vertical track using the left Quick Install Bracket. You should encounter some resistance when pushing down on the QI-bracket. If needed, use a flat blade screwdriver against the top edge of the bracket and gently tap into position with a hammer.

NOTE: It is very important that both brackets are mounted at the same height so sensors align.

9