Read These Important Safety Rules Before Proceeding
This symbol indicates caution and appears throughout this instruction manual. This garage door opener is designed and tested to offer reasona- bly safe operation if installation is followed in strict accordance with these safety instructions. Failure to comply with these instructions may result in serious personal injury or property damage.
IMPORTANT INSTALLATION INSTRUCTIONS
WARNING: To reduce the risk of severe injury of death:
READ AND FOLLOW ALL INSTALLATION IN- STRUCTIONS.
Install only on a properly balanced garage door. An improperly balanced door could cause severe injury. Have a qualified service person make re- pairs to cables, spring assemblies and other hardware before installing opener.
To reduce the risk of injury to persons, use this operator only with sectional overhead doors.
Fiberglass, aluminum and steel doors must be re- inforced to prevent damage to the door. Check with your garage door manufacturer for their rec- ommendations.
Remove all ropes and remove or make inoperative all locks connected to the garage door before in- stalling opener.
Do not use sensitivity adjustments to compensate for a poorly operating door. This will interfere with the proper operation of the safety reverse mechanism and may damage the door.
Locate control button: within sight of door, at a minimum height of 5 feet, so small children can- not reach it, and away from all moving parts of the door.
If possible, install door opener 7 feet or more above floor. Mount the emergency release knob 6 feet above the floor.
Do not connect opener to source of power until instructed to do so.
Installation and wiring must comply with local building and electrical codes. Connect the power cord to a properly grounded outlet. Do not re- move round ground pin from power cord.
Install entrapment warning label next to control button in a prominent location, such as the inside of the garage door, or as instructed in the installa- tion instructions. If label adhesive will not adhere to the surface, secure the label by additional me- chanical means such as staples, nails or screws. If necessary, use an intermediate mounting sur- face, such as plywood, cut to the appropriate size. Install Emergency Release tag to the emergency red cord.
After installing opener, the door must reverse when it contacts a 1 inch high solid test object on the floor.
Open door must not close and closing door must open if photoelectric system in obstructed by 6” x 12” object, using test procedure described in Step 30.
Do not wear rings, watches or loose clothing when installing or servicing a garage door sys- tem. Use a sturdy,
AFTER INSTALLATION IS COMPLETE, FASTEN THIS MANUAL NEAR GARAGE DOOR.
PERFORM PERIODIC SAFETY CHECKS, MAINTENANCE AND ADJUSTMENTS, AS RECOMMENDED.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment gener- ates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inter- ference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Warning: Changes or modifications to this unit not ex- pressly approved by
FCC Regulatory Information: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IC Regulatory Information: This Class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment Regula-
tions. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must ac- cept any interference received, including interference that may cause undesired operation.
2
