Quantum Audio PX502 quick start b Remove the metal restraints from the library

PX502 Tape Library Quick Start Guide

5After the library has powered down, remove the foam restraints by completing the following steps (see figure 20):

a Detach the tie band holding the two sides of the metal restraints together and remove it from the library.

b Remove the metal restraints from the library.

c Lift the left foam restraint slightly up and remove it from the library.

d Slide the right foam restraint to the right until you are clear of the robotics motor and remove the restraint from the library.

CAUTION: Avoid touching the printed circuit board.

CAUTION: When removing the foam restraints, ensure that the robotics umbilical cable is lying down in the correct position inside the platform and not across the robotics track.

Figure 20 Removing the Foam Restraints

Tie band

Metal restraint

Foam restraints

Metal restraint

Robotics umbilical cable

NOTE: Save the robotics restraints and re-usable tie wrap for later shipping or relocation of the library.

eInstall the tape cartridge magazines.

NOTE: Refer to the PX500 Series User’s Guide (PN 81- 81290) for more information on loading the tape cartridge magazines.

fClose the front doors.

gIf you have removed the top cover for better access, install the top cover back on the library.

13