Radio Shack 15-2130 owner manual Manual Code Search, Auto Code Search

Remote Control

MANUAL CODE SEARCH

If the Guide Remote* does not operate your device, when set up, you may not have entered the correct 4-digit code. You may manually search for codes in each device category to locate one that operates your brand of device. See page 26 for list of Manufacturer’s codes. To manually search for a codes that works on your device perform the following steps.

1.Press device key (TV, VCR, CBL/SAT or DVD). The red light blinks one time.

2.Press the P key. The red light blinks two times.

3.Press the 0 0 0 0 digit keys. The red light blinks one time.

4.Press the P key. The red light blinks three times.

5.Press any IR key (POWER, CH+, CH-, VOL+, VOL-,etc.). The red light blinks one time for each key pressed.

6.If the device operates the desired function, press the device key (TV, VCR, CBL/SAT or DVD to exit and save the code. The red light blinks one time.

7.If the device does not operate the desired function, press the P key then the desired IR key(s), (POWER, CH+, CH-, VOL+, VOL-,etc.) again. Repeat the process until you find a code that operates your device.

8.Once you find a code that works press the device key (TV, VCR, CBL/SATor DVD) to exit and save the code.

AUTO CODE SEARCH

The remote can perform an auto-search to locate a code that operates your devices. To allow the remote to perform an auto-search for a code perform the following steps.

1.Press the desired device key (TV, VCR, CBL/SAT or DVD) on which to perform a code search. The red light blinks one time.

2.Press the P key. The red light blinks two times.

3.Press the 7 digit key. The red light blinks one time.

4.Press the P key. The red light blinks three times.

5.At 2.5-second intervals, the remote will send POWER key commands. If the device does not have a power code, the remote will send the following commands in order, PLAY, CH+ and MUTE IR. If none of these commands exists for the device, the device is skipped.

6.Press the device key (TV, VCR, CBL/SAT or DVD) to stop auto-search and save the code. Press any other key except device key to terminate the search without saving a code. The P key is ignored if pressed to terminate auto search.

Note: It may take up to several minutes to locate a code that operates the device.

9 Manual Code Search