Radio Shack 15-2130 owner manual Install Batteries, Battery Saver, Adjust Contrast

INTRODUCTION

INSTALL BATTERIES

The battery cover is located on the back of the remote. Pay close attention to the direction of the batteries. Align the poles (+ and -) as indicated in the battery compartment. Remove battery case cover to install the batteries in the remote control.

1.Press firmly on the arrow on the back of the remote to remove the battery cover.

2.Insert four new 1.5-volt AA alkaline batteries, taking care to align the polarity symbols ( + and - ) as marked inside the battery case.

3.Replace the battery cover.

Notes:

•Use only fresh AA alkaline batteries.

•Do not use rechargeable batteries.

•Do not mix old and new batteries.

•Promptly remove old or weak batteries since they can leak chemicals that can destroy electronic parts.

BATTERY SAVER

If a key on the remote becomes stuck or held for an extended period, the remote will stop sending IR signal after 30 seconds.

ADJUST CONTRAST

Adjust the contrast on the screen of your new Guide Remote. Each time batteries are removed and replaced in the Guide Remote; you can adjust the contrast on the display screen to your desired level.

To adjust the contrast level, repeatedly press the left or right arrow keys located directly below the display screen.

7 Install Batteries