Radio Shack 3-DVD Changer Selecting TV Aspect, Selecting Digital Audio OUT, Setting a Password

5. Press DVD SET UP to exit.

Notes:

•Some titles do not match with the rating level described as above.

•If you change the level and enter a password, playback of all DVDs with ratings higher than your selection will be blocked, unless you enter the correct password again. For example: if you change the level to 5, the DVD player will not play discs with rat- ings of 6, 7, or 8 unless the correct password is entered from the remote control.

Setting a Password

If you change the rating level to 7 or lower, you must enter a 4-digit password to access playback of discs with higher ratings.

To set this password, follow these steps.

1.Press DVD SET UP.

2.At the setup screen, press 9 to select F7IIMEH:, then press

ENTER.

3.Type a 4-digit password into EB:. (For example, 1234).

Important: Do not forget your password.

4.Type same the 4-digit password into D;M, then press ENTER.

Clearing Your Password

If you forget your password, you can clear the current password.

At the SETUP screen, press 9 to select F7IIMEH:, then press EN- TER.

Enter 4-digit number (for example, 2850), then press ENTER. The 4- digit password is cleared.

SELECTING TV ASPECT

Select the appropriate screen type according to your TV set. Conven- tional size screens use a 4:3 aspect ratio, and wide-screens use a 16:9 ratio.

1.Press DVD SET UP.

2.At the setup screen, press 8 or 9 to select JLý:?IFB7O, then press ENTER.

3.Repeatedly press ENTER to select the desired aspect, then press DVD SET UP. You must select the type of TV picture (aspect ratio) that corresponds to the type of TV you are connecting to the DVD unit.

*0)ýFI (Pan & Scan) — If you have a conventional TV set and your DVD is not formatted for widescreen viewing, use this set- ting.

*0)ýB8 (Letterbox) — If you have a conventional TV set and your DVD is formatted for widescreen viewing, use this setting. All video material not formatted in the Pan & Scan style is played back in the letterbox style. Black bands appear at top and bottom of screen.

',0/ýM?:; (Widescreen) — If you have a wide-screen TV set, use this setting. The DVD plays in full size. (You must also set your widescreen TV to “full size”).

SELECTING DIGITAL AUDIO OUT

Each DVD has a variety of audio output options. If you connected a device to the receiver’s digital optical jacks (see “Connecting a Digital Optical Audio Devices” on Page 7), you might have to change the digital audio output setting. Set the player’s Digital Audio Output ac- cording to the type of audio system you use.

1.Press DVD SET UP.

2.At the setup screen, press 8or 9 to select :?=?J7BýEKJ.

3.Repeatedly press ENTER to select the desired output (F9C or 8?JIJH;7C) , then press ENTER.

8?JIJH;7C — Select 8?JIJH;7C if you have an amplifier or other equipment with DTS decoder or Dolby Digital decoder connected to the receiver.

F9C — Select F9C if you have an amplifier or other equipment with linear PCM only (or a MD recorder or a DAT deck) con- nected to the receiver.

Caution: If an active digital audio output signal is supplied to an re- ceiver or other equipment without a corresponding digital decoding capability, a very loud noise may be produced which could perma- nently damage the speakers.

Note: When you make a digital recording from CD to your house au- dio CD recorder entire CD tracks are recorded as 1 track. This is be- cause there is no track information.

20 DVD Player Operation