Additional Information, Headset Installation | Radio Shack 43-3557

Additional Information

Ô NOTES Ô

•If you place the handset on the base to recharge it while the headset is connected, be sure the handset seats properly.

•You can use a handset holder (available from your local RadioShack store) to hang the handset on your belt for greater convenience when using a headset.

ADDITIONAL

INFORMATION

INSTALLING THE BELTCLIP

To attach the beltclip

Insert the beltclip into the holes on each side of the handset. Press down until it clicks.

To remove the beltclip

Pull both sides of the beltclip to release the tabs from the holes.

HEADSET INSTALLATION

You can connect an optional headset with a 3/32-inch (2.5-mm) plug. Contact RadioShack for a suitable headset.

To connect the headset, open the rubber cover on the side of the handset. Then insert the headset’s plug into the jack.Ô

When you finish using the headset, disconnect it from the handset and close the rubber cover to protect the jack.

32

Image 32

Radio Shack 43-3557 Additional Information, To attach the beltclip, To remove the beltclip, Installing the Beltclip

Contents

GHz Cordless Telephone Caller ID/Call Waiting ID Contents Introduction Introduction Important Information InformationFCC Statement Surge Protection Important Safety Instructions Important Safety Instructions Important Caller ID Information Important Caller ID Information Selecting a Location InstallationInstallation On a Wall Plate or Wall On a Desk TOP CONNECTING/CHARGING the Battery Pack Installation Installation Operation OperationMaking and Receiving Calls Handset Ringer Tone and Volume Earpiece VolumeAdjusting the Handset Ringer and Earpiece Volume Temporarily Mute Ringer Selecting a Different Channel Tone Dialing SWITCH-OVERTraveling OUT-OF-RANGE Flash and Call Waiting Voice Mail Waiting IndicatorVoice Mail Waiting Indicator Setting Menu Options Choosing the Dialing ModeChanging the Auto Talk Entering Your Area Code Choosing the Dialing Mode Setting the Language Memory DialingStoring Phone Numbers and Names Memory Dialing See Steps for Entering Names and Special Characters on Steps for Entering Names and Special Characters Use PAUSE/REDIAL to enter a pause If you make a mistake while entering a name Memory Dialing from Standby Mode Memory Dialing from Talk ModeMaking Calls with Memory Dialing Chain Dialing Editing a Stored Name AND/OR Phone Number Erasing a Stored Name and Phone Number Use the number key, /TONE/, # Testing Stored Emergency Numbers ONE-TOUCH Speed Dial Deleting the Speed Dial Storing and Editing the Speed Dial ÔMaking Calls with the Speed Dial Caller ID When the Telephone RingsCaller ID Deleting a Caller ID Message Viewing the Caller ID Message ListDeleting Information from the Caller ID List Viewing the Caller ID Message List Using the Caller ID List Deleting all Caller ID Names/ Numbers ÔCalling a Party from the Caller ID List Deleting all Caller ID Names/Numbers Long Distance Calls and Area Code Setting/Cancellation Long Distance Calls Area Code Setting CancellationStoring Caller ID Messages in Memory Dialing Storing Caller ID Messages in Memory Dialing Installing the Beltclip Headset InstallationAdditional Information To attach the beltclip Troubleshooting Problem Solution Care Service and RepairCare Page RadioShack Corporation