connected, be sure the handset seats properly.
•With a headset connected, you make or answer calls as usual using the keys on the handset.
•You can use an optional handset holder (available from your local RadioShack store) to hang the handset on your belt for greater convenience.
MEMORY DIALING
You can store up to 10 phone numbers and names in memory, then dial a stored number by entering its memory location number.
Each number can be up to 20 digits, and each name can be up to 14 characters.
Storing a Name and Number in Memory
When you are storing a number in memory, an error tone sounds and the phone exits the storing process if you wait more than 20 seconds between each keypress. If you receive a call during memory entry, the phone exits the storing process.
To store a number and name in memory:
1.Lift the handset.
2.Hold down MEM until C[cehoýIjeh[ and a list of memory location numbers appear.
3.Press the appropriate numbers
4.Press SELECT. Ijeh[ýDWc[ appears. If you do not want to enter a name, skip to Step 6.
5.To enter a name, use the number keys.
Refer to the letters on the number keys to select the desired letter. Press the key once for the first letter in the upper case,
press twice for the second letter in the upper case, and so on. To enter the lower case letter, press four times (or five times) to display the first letter in lower case, five or six times for the second letter, and so on.
For example, to enter John: press 5 once; upper case @ appears. Then press 6 six times; lower case e appears. Press 4 five times; lower case ^ appears. Finally, press 6 five times; lower case d appears.
To enter two letters from the same key in a row, press #/7 to move the cursor to the next position. For example to enter AB, press 2; 7 appears. Then press #/7, the cursor moves to the next position, then press 2 twice so 8 appears.
To enter a space, press #/7 twice without entering any character.
To enter a number, repeatedly press the corresponding number key until the number appears.
To enter a special character, use 0. Each time you press 0, the following characters appear in this order:
-ýçý#ý)ýâýá (space) &
If you make a mistake, use TONE/6/* or #/7 to move the cursor over the error, then enter the correct character, or press DELETE to delete a character. To delete all characters, briefly hold down
DELETE.
6.Press SELECT. Ijeh[ýDkcX[hýappears.
7.Enter the phone number and any tone or pause entries (see “Using Tone Services on a Pulse Line” on Page 12 and “Entering a Pause” on Page 14).
Note: Each tone or pause entry uses one digit of memory.
Telephone Operation | 13 |
