•near a modular telephone line jack
•out of the way of normal activities
•away from electrical machinery, electrical appliances, metal walls or filing cabinets, wireless intercoms, alarms, and room monitors
•away from other cordless phones
You can try different locations to see which provides the best performance.
Cautions:
You must use a Class 2 power
!source that supplies 9V DC and delivers at least 350 mA.
Its center tip must be set to positive and its plug must fit the phone's DC IN 9V jack. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the phone or the adapter.
•Always connect the AC adapter to the phone before you connect it to AC power. When you finish, disconnect the adapter from AC power before you disconnect it from the phone.
Your telephone connects directly to a modular telephone line jack. If your telephone wiring does not have a modular jack, you can update the wiring yourself using jacks and adapters (available at your local RadioShack store), or have the telephone company update the wiring for you. You must use compatible modular jacks that are compliant with Part 68 of FCC Rules.The USOC number of the jack to be installed is RJ11C (RJ11W for a wall plate).
On a Desk Top
1.Plug one end of the supplied long modular cord into the TEL LINE jack on the base’s back.
2.Plug the modular cord’s other end into a modular telephone line jack.
3. Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back.
4. Route the adapter’s cord through the strain relief slot on the base’s bottom.
5.Plug the adapter into a standard AC outlet.
6.Lift the base’s antenna to a vertical position.
On a Wall Plate or Wall
1. Insert the two tabs
at the top of the narrow end of the supplied bracket into the base’s upper tab slots, then press down
on the bracket’s latches and insert them into the lower slots.
2.Plug one end of the supplied short modular cord into the TEL LINE jack on the base’s back.
3.Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack.
4.Route the adapter and modular cords through the bracket’s grooves.
5.Plug the modular
cord’s other end into the wall plate jack, then align the bracket’s keyhole slots with the wall
Installation | 7 |
