Radio Shack 43-3817 owner manual 75+0610548+%510#27.5, #+0, 75+0#*#&56, 14&+#.+0

75+0)"610'"5'48+%'5"10"#"27.5'"

.+0'

Some special services, such as bank-by-phone, require tone signals. If you have pulse service, you can still use these special tone services. Dial the service’s main number. When the service answers, press ∗6/TONE. Any additional numbers you dial are sent as tone signals.

When you hang up, the phone automatically resets to pulse dialing.

2#)+0)

To page the person who has the handset or to locate the handset when the phone is not in use, press PAGE on the base. The handset beeps for about one minute. To stop it from beeping sooner, press any key on the handset or return the handset to the base. Press PAGE again to stop the paging at the base.

75+0)"#"*'#&5'6

You can connect an optional headset with a 3/32- inch (2.5-mm) plug. Contact RadioShack for a suitable headset.

To connect the headset, open the rubber cover on the side of the handset, then insert the headset’s plug into the jack.

When you finish using the headset, disconnect it from the handset and close the rubber cover to protect the jack.±ý

/'/14;"&+#.+0)

You can store up to 10 phone numbers and names in memory, then dial a stored number by entering its memory location number. Each number can be up to 20 digits, and each name can be up to 14 characters.

±"016'"±"

•Connecting a headset disconnects the handset’s earpiece and microphone.

•8 or 9 on the handset also controls the connected headset’s volume.

•If you place the handset on the base to recharge it while the headset is connected, be sure the handset seats properly.

•With a headset connected, you make or answer calls as usual using the keys on the handset.

•You can use an optional handset holder (available from RadioShack) to hang the handset on your belt for greater convenience.

Telephone Operation

17