Installation

 

 

#"+/2146#06"#

 

 

 

Be sure the battery pack is

 

 

 

 

 

 

properly connected before

 

 

 

you try to charge it. The

 

 

 

CHARGE/IN USE indicator

 

 

 

lights when the handset is

 

 

 

on the base even if the

 

 

 

battery pack is not

 

 

 

connected properly.

 

 

 

 

 

 

 

 

 

 

 

±"016'"±"

 

 

 

 

• If the phone does not

 

 

 

 

work, recharge the

 

 

 

 

battery pack. (The

 

 

 

 

battery power might be

 

 

 

 

too low for the display to

 

 

 

 

operate.)

 

 

 

 

• If the battery pack

 

 

 

 

becomes weak during a

 

 

 

 

call, the handset beeps

 

 

 

 

about every 3 seconds

 

 

 

 

and TALK/BATT flashes.

 

 

 

 

When this happens, you

 

 

 

 

cannot make a call on

 

 

 

 

the phone until you

 

 

 

 

recharge the battery

 

 

 

 

pack.

 

 

 

 

• If the battery pack is

 

 

 

 

completely discharged

 

 

 

 

or the base loses power

 

 

 

 

while the handset is

 

 

 

 

away from it, place the

 

 

 

 

handset on the base to

 

 

 

 

reset the security

 

 

 

 

access-protection code.

 

 

 

 

If it was the handset that

 

 

 

 

lost power, recharge the

 

 

 

 

battery pack.

 

 

 

 

 

 

6. Lift the base’s antenna to a vertical position.

%100'%6+0)."%*#4)+0)"#0&" 4'2.#%+0)"6*'"$#66'4;"2#%-

The phone comes with a rechargeable Ni-Cd (nickel-cadmium) battery pack installed in the handset, but not connected. Before using your phone, you must connect the battery pack, then charge it for about 24 hours.

1.Press down and slide off the battery pack compartment cover.

2.Lift the battery pack out of the compartment.

3.Plug the battery

pack’s connector into the socket in the compartment. The connector fits only one way.

4.Put the battery pack in the compartment.

5.Replace the cover.

To charge the battery pack, place the handset on the base, face up or down. The base’s CHARGE/IN USE indicator lights. #"

Recharge the battery pack when the handset beeps and TALK/BATT flashes. ±ý

When you first use the phone after charging or recharging the battery pack, the phone might not work and you might hear error beeps. If this happens, return the handset to the base for about 5 seconds to reset the security access-protection code.

Using a pencil eraser, clean the charging contacts on the handset and the base about once a month.

10

Page 10
Image 10
Radio Shack 43-3821 owner manual 100%6+0.%*#4+0#0& 42.#%+06*$#6642#%