Installation
±"016'"±"
The phone exits the setting mode if you:
-wait more than 2 seconds between key presses
-receive an incoming call
-press PLAY/STOP
-press TALK on the handset
If the phone exits the setting mode, start again at Step 1.
If your phone system requires that you dial an access code (9, for example) before you dial an outside number, do not dial the access code.
The phone exits setting mode if a call or page is received, or if you press END.
If the battery power is too low, the dialing mode might reset to tone. If you are on a pulse line and cannot make a call, try resetting the dialing mode to pulse.
5'66+0)"6*'"*#0&5'6N5"4+0)'4" 610'
You can select either a high or low ringer tone setting while the phone is not in use.
Lift the handset and press VOL/RING to hear the current ringer setting. Repeatedly press VOL/RING to select the desired ringer setting.
6740+0)"6*'"$#5'N5"4+0)'4"101 1(("
You can set the base’s ringer to high or low, or turn it off.
1.Press SET/RING. The phone’s currently set ring sounds, and the current setting appears.
2.Repeatedly press SET/RING to change to the
desired setting. The system rings at the setting
and >_, Be, or E\ appears. When the ringer is set to E\, the phone announces “Off.” ±ý
Even when you turn off the base’s ringer, you can still make or receive calls using this phone. Telephones on the same line and the handset (if its ringer is not turned off) still ring when there is an incoming call.
12
