10"#"9#.."14"9#.."2.#6'

To mount the base directly on the wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the bottom of the bracket. Drill two holes 315/16 inches apart. Then thread a screw into each hole, letting the heads extend about 5/32 inch from the wall.

1. Insert the two tabs at the top of the narrow end of the supplied bracket into the base’s upper tab slots, then press down on the bracket's latches and insert them into the clip slots.

2.To connect the phone to a two-line phone jack, plug

one end of the supplied long modular cord into the TEL LINE 1/2 jack on the back of the phone.±

To connect the phone to two one-line phone jacks, plug one end of the supplied short two-line modular cord into TEL LINE 1/2 and plug another cord (not supplied) into the TEL LINE 2 jack.

To connect the phone to a single one-line phone jack, plug one end of the supplied long modular cord into the

TEL LINE 1/2 or TEL LINE 2 jack.

3.Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back of the base.

4.Route the adapter’s

cord through the narrow groove on the bracket. If you are using two phone cords, route the second cord through one of the wide grooves on the bracket.

±"016'"±"

 

If you connect the phone to a two-

 

line phone jack with a two-line

 

cord, do not connect a cord to the

 

TEL LINE 2 jack or the phone will

 

not operate properly.

Installation

 

7

Page 7
Image 7
Radio Shack 43-683 owner manual 10#9#..149#..2.#6