±"016'"±"
5.To mount the phone on a wall
plate, plug the other end of the short modular cord into the
wall plate jack, then align the
bracket’s keyhole slots
with the wall plate studs and
slide the base
downward to secure it. If you are using two phone cords, plug the second cord into the second phone jack.
Installation
• If the base loses power for 60 |
minutes while the handset is |
away from it, the security code |
might be lost. To reset the code, |
return the handset to the base |
for about five seconds. |
• Using a pencil eraser, clean the |
charging contacts on the |
handset and base about once a |
month. |
• If the battery pack becomes |
weak during a call, the handset |
beeps every three seconds and |
Bemý8Wjj[ho flashes. When this |
happens, you cannot make a |
call until you recharge the |
battery pack. |
• About once a month, fully |
To mount the phone directly on a wall, align the bracket's keyhole slots with the mounted screws and slide the base downward to secure it. Connect the phone cord(s) to the modular phone line jack(s).
6.Plug the adapter into a standard AC outlet.
TEL LINE 2
DC IN 9V | TEL LINE 1 / 2 |
discharge the battery by |
keeping the handset off the |
base until Bemý8Wjj[ho flashes. |
Otherwise, the battery pack |
loses its ability to fully |
recharge. |
• If the display is blank and the |
phone does not work, recharge |
the battery pack. (The battery |
power might be too low to light |
the display.) |
• If you are not going to use your |
phone for an extended period of |
time, disconnect the battery |
pack. This increases the battery |
pack's usable life. |
7.Press and lift out the handset holder, flip it over, then snap it back into place to hold the handset.
8.Raise the base’s antenna to a vertical position.
%100'%6+0)"#0&"%*#4)+0)"6*'" $#66'4;"2#%-
The phone comes with a rechargeable
1.Press down and slide off the battery pack compartment cover.
2.Lift the battery pack out of the compartment.
8
