Installation

±"016'"±"

Connecting to Phone Lines

The line that connects a two-line phone jack to the phone company wiring must be twisted-pair cable. Otherwise, you might hear interference (crosstalk) between the two lines.

The USOC number of the two- line jack to be installed is RJ14C (RJ14W for a wall-plate). The USOC number of a single-line jack is RJ11C.

On a Desk Top

If you connect the phone to a two-line phone jack with a two- line cord, do not connect a cord to the TEL LINE 2 jack or the phone will not operate properly. Instead, you can connect another phone device, such as a fax machine or modem.

If you connect the phone to a single one-line phone jack, avoid pressing the unused line button or you might hear feedback.

."%#76+10".

You must use a Class 2

!power source that supplies 9V AC and delivers at least

350 mA. Its center tip must be set to positive and its plug must fit the phone's DC IN 9V jack. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the phone or the adapter.

Always connect the AC adapter to the phone before you connect it to AC power. When you finish, disconnect the adapter from AC power before you disconnect it from the phone.

%100'%6+0)"61"2*10'".+0'5

To take full advantage of the phone’s capabilities, you must have two phone lines with separate phone numbers. If you have only one line, you can order a second from your phone company.

You can connect the phone to the lines in one of three ways:

connect two lines through a two-line modular phone jack

connect two lines through two one-line modular phone jacks

connect one line through a one-line modular phone jack.

Your telephone connects directly to a modular telephone line jack. If your telephone wiring does not have a modular jack, you can update the wiring yourself using jacks and adapters (available at your local RadioShack store or online at RadioShack.com), or have the telephone company update the wiring for you. You must use compatible modular jacks that are compliant with Part 68 of FCC Rules.±

10"#"&'5-"612

1.To connect the phone to a two-line phone jack, plug

one end of the supplied long two-line modular cord into the TEL LINE 1/2 jack on the back of the phone. ±

To connect the phone to two one-line phone jacks, plug one end of the supplied long two-line modular cord into TEL LINE 1/2 and plug another cord (not supplied) into the TEL LINE 2 jack.

To connect the phone to a single one-line phone jack,

plug one end of the supplied long modular cord into the

TEL LINE 1/2 or TEL LINE 2 jack.±

2.Plug the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back of the base..

3.Route the adapter’s cord through the strain relief slot on the bottom of the bracket.

4.Plug the adapter into a standard AC outlet.

5.Connect the phone cord(s) to the modular phone line jack(s).

6.Lift the base’s antenna to a vertical position.

6

Page 6
Image 6
Radio Shack 43-683 owner manual 100%6+0612*10.+05, 10#&5-612, To connect the phone to a two-line phone jack, plug