Notes:
•The supplied motion detector (Cat. No.
If you want to use the exit/entry delay feature, you can use another motion detector (Cat. No.
•You must set the switch inside the door/window sensor transmitter’s battery compartment to MAX in order for it to arm in the delay mode. When set to MIN, the sen- sor transmitter immediately arms, regardless of whether the hand- held remote control is set to
DELAY or INSTANT.
•The ARM button on the console automatically arms the system in the DELAY mode.
•The keychain remote control only arms the system in the INSTANT mode.
•Other separately purchased remote controls might arm the system only in either the DELAY or INSTANT mode. See the remote control’s owner’s manual.
•The system ignores sensor trans- mitters operating in the MIN mode (such as the supplied motion detector) during the entry delay.
24
Trouble Alarm
If you hear a repetitive trouble alarm when you try to arm the system, this in- dicates that there is a problem.
The system does not arm until you:
•Correct the Problem — Press DISARM to stop the trouble alarm. Check the zone reporting the problem to see if a door or window is open or a sensor transmitter’s battery is dead. Then arm the sys- tem again.
•Ignore the Problem — Press BYPASS on the console while the trouble alarm is sounding. The problem zone’s indicators flash rapidly. Press ARM HOME/ARM AWAY to arm the system. The problem zone(s) are not pro-
tected, but all other zones arm.
PANIC
| AWAY - ARM - HOME | |
| BYPASS | ZONES |
| ON - LIGHTS - OFF | |
| plug'n power | |
| C O M P A T I B L E | |
MONITOR | AC POWER | BATTERY LOW |
Note: If you bypass an open window or door, arm the system, and later close the window or door, that zone arms.