Problem | Solution |
|
|
The red indicator on the sen- | Remove then reinstall the sensor transmitter/motion de- |
sor transmitter/motion detec- | tector’s batteries. Press TEST again. |
tor stays on during installation. |
|
|
|
The ARMED indicator is flash- | This indicates that there has been an intrusion. Also, if a |
ing. | zone indicator is on, this indicates which zone was violat- |
| ed. To turn the zone indicator off and stop the armed in- |
| dicator from flashing, press the ARM or DISARM button on |
| a remote control. If a zone indicator is not on, the violated |
| zone is within Zones |
| sole to see which zone was tripped. |
|
|
A motion detector causes false | • Motion detectors sense motion by detecting a |
alarms. | change in temperature; therefore, do not place the |
| motion detector near an air conditioning or heating |
| vent. |
| • Do not place it in a direct source of bright light, such |
| as sunlight. |
| • It could be detecting a pet’s movements. Set the |
| switch on the back to 2 so it is less sensitive or |
| cover its bottom zones. |
|
|
31