QUICK START GUIDE (CONTINUED)
SETTINGUPTHE REMOTE
The remote is preprogrammed at the factory to
operate an RCA TV,VCR,DVD and satellite receiv-
er,and Pioneer CD and audio devices.To control
devices other than the default brands,perform the
following steps and repeat them as needed for
each device to be programmed; otherwise skip
this section.
Direct code set up
TOSETUPTHE REMOTE FOR YOURTELEVISION:
1.Find your device code in the Manufacturer’s
code section (page 46 – 60).
Codes are listed by device type and brand
name.The most popular code for each brand is
listed first.
2.Make sure your television is switched on.
3.Press and release TV.
4.Hold down Pfor at least 3 seconds. The bottom
ofthe IR Indicator blinks twice,and a circle
appears around P.
5.Enter your four-digit code using the number
keys.The bottom of t he IR Indicator blinks
once after each of the first three digits are
entered.After the fourth digit,it blinks twice to
confirm that a valid four-digit code has
been entered.
6.Aim your remote at your television and press
POWER.Ifyour television switches off,your
remote is ready to cont rol your television.
• IFYOURDEVICEDOESNOT RESPOND,FOLLOWSTEPS 1 THROUGH 6 WITH
EACHCODELISTED FOR YOUR BRAND.IFNONEOFTHECODESLISTEDFOR
YOURBRAND OPERATE YOUR DEVICE,SEE“SEARCH METHOD”ON PAGE
12 FOROTHER OPTIONS.
• SOMECODES ARE QUITE SIMILAR.IFYOURDEVICEDOESNOT RESPOND
ORIS NOT FUNCTIONING PROPERLYWITH ONE OF THE CODES,TRY
ANOTHERCODE LISTEDUNDER YOUR BRAND.
• IFTHEORIGINAL REMOTECONTROL FROM YOURVCR DID NOT HAVE A
POWERKEY,PRESSPLAYINSTEAD OF POWER DURING STEP 6.
• TOSETUPYOUROTHER DEVICES,FOLLOWTHE SAME INSTRUCTIONS
ABOVE,BEINGSURE TOPRESS THE APPROPRIATE DEVICE KEY DURING
STEP3.
• REMEMBERTO PRESS THE CORRECT DEVICEKEY BEFORE OPERATING
YOURD EVICE.ONLYONEDEVICE (CD, AMPLIFIER,CABLE,ETC.) CANBE
10 Quick Start Guide
6-IN-ONE
RadioShack_Kameleon_v3b.qxd 4/10/03 3:22 PM Page 10