MEMORY DIALING
You can store up to 20 phone numbers and names in memory, then dial a stored number by entering its memory location number.
Each number can be up to 20 digits, and each name can be up to 13 characters.
Storing a Number and Name in Memory
Notes:
•An error tone sounds and the phone exits the storing process if you wait more than 20 seconds between each keypress.
•If you receive a call during memory entry, the phone exits the storing process.
1.Lift the handset.
2.Hold down MEM until Memory Store and a list of memory loca- tion numbers appears.
3.Press a number
– 01, 02, 03, and so on.
4.To store a name, press CH/SELECT.
Store Name appears.
If you do not want to enter a name, skip to Step 6. <Memory nn> will appear to identify the number (nn is the location number you selected).
5.To enter a name, press VOL/CID 
or 
to select the characters and
/
or #/ 
to move the cursor.
Repeatedly press VOL/CID 
to view the characters in alphabetical order. (The display shows upper- case letters first, then lowercase let- ters, numbers, and special characters.)
Notes:
•Press VOL/CID 
to see the char- acters in reverse alphabetical order.
•You can hold down VOL/CID 
or
to scroll rapidly through the characters.
•If you make a mistake, move the cursor over the error, then enter the correct character, or press DELETE to delete a character. To delete all the characters, hold down DELETE for at least 1 sec- ond.
6.Press SELECT. Store Number ap- pears.
7.Enter the phone number and any tone or pause entries (see “Using Tone Services on a Pulse Line” on Page 15 and “Entering a Pause” on Page 17).
8.Press SELECT. The phone beeps and Memory nn Stored appears. After 2 seconds, Memory Store appears. Repeat Steps
9.When you finish, press MEM.
To replace a stored number, store a new one in its place.
16
