5.Insert the tabs on the narrow end of the bracket into the upper slots on the bottom of the base, then push the tabs on the wide end of the bracket into the lower slots on the bottom of the base.
MOUNTING THE BASE DIRECTLY ON THE WALL
For this mounting method, you need two
1. Drill | two | holes | 315/16 | 3/16" | |||||
inches (100 mm) apart. |
|
|
|
|
|
| |||
Then | thread a | screw |
|
|
|
|
|
| |
|
|
|
|
|
| ||||
into each | hole, | letting |
|
|
|
|
|
| |
the | heads | extend | 315/16" |
|
|
|
| ||
about | 3/16 inch (5 mm) |
|
|
|
| ||||
|
|
|
|
|
| ||||
from the wall. |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
6.Plug the short modular cord into the wall plate jack, align the base’s key- hole slots with the wall plate studs, and slide the base downward to secure it.
7.Plug the adapter into a standard AC outlet.
8.Lift the base’s antenna to a vertical position.
2.Remove the bracket by holding in both tabs and gently pulling out the wide end of the bracket.
3.Plug one end of the supplied long modular cord into the phone jack on the back of the base. Route the modular cord through the left slot on the bottom of the base and pull the cord down to remove any slack on top.
Phone Jack
9
