quency. The display indicates the bank and channel number. After about 1 sec- ond, the frequency to be copied flashes.
3.Press ENTER. All the conditions such as receiving mode and delay condition are copied on the channel. á?8Eý /KFI<ü briefly appears. The scanner automati- cally returns to search mode.
If you try to copy a frequency which is already stored, the scanner sounds the notice tone 3 times after you press ENTER. LGCô=ý á?OOO appears at the bottom line. If you want to copy the duplicate frequency anyway, press ENTER, or if not, press CLEAR to cancel.
Copying a Frequency into a Vacant Channel in a Specified Bank
You can copy a frequency into a vacant channel in a specified bank when the scan- ner stops on the frequency during search or tune mode.
1.Press FUNC then ENTER when you find a frequency you want to copy. â8EBé /KFI<å appears.
2.If you want to copy the frequency into bank 9, press ENTER. It is stored in the first available vacant channel in the bank. Or, press your desired bank num- ber to store, then press ENTER. á?8E /KFI<ü appears for 2 seconds. All the conditions such as receiving mode and delay condition are copied on the chan- nel. After about 2 seconds, the scanner automatically returns to search mode.
3.If you try to copy a frequency which is already stored, the scanner sounds the notice tone 3 times after you press ENTER. LGCô=ý á?OOO appears at the bottom line. If you want to copy the duplicate frequency anyway, press ENTER, or if not, press CLEAR to cancel.
Copying a Frequency into the Pri- ority Channel
You can copy a frequency into the priority channel (see “Priority” on Page 27) when the scanner stops on the frequency during Search, Scan, Manual, Tune, or WX mode.
Press FUNC then PRI when the frequency is on the display. The display flashes twice and the frequency is copied to the priority chan- nel.
SCANNING THE CHANNELS
To begin scanning channels or to start scan- ning again after monitoring a specific chan- nel, press SCAN.
Note: You must store frequencies into chan- nels before the scanner can scan them. The scanner does not scan through empty chan- nels.
The scanner scans through all channels (ex- cept those you have locked out) in the active banks (see "Turning
Note: To change the scanning direction, press 8or 9.
Turning Channel-Storage Banks Off and On
To turn off banks while scanning, press the bank's number key so the bank's number disappears. For example, to turn off bank 1, press 1. The scanner does not scan any of the channels within the banks you turned off.
Operation | 25 |
