Radio Shack PRO-2053 owner manual Storing Talk Group IDs, 8Wdaý&#, ?ýDe$ý CEJ0ýded

)<DFIPý =LCCü

Block

Size Code

9 10 11 12 13 14 15 16

7

S0

S4

S0

S4

S0

—

—

—

6.Press ENTER for each entry. If you make a mistake, press CLEAR and enter the correct size code.

Notes:

•The default setting of the bank is for Motorola Type II. However, if you set Type I and you want to return to Type II, enter 15 at Step 5.

•To confirm the input, repeat Steps 1– 5 and press ENTER. Each time you press ENTER, you confirm the size code. If you find an error, press CLEAR and begin again at Step 1.

7.Press SCAN to start scanning.

Talk Group IDs

There are 10 talk group ID banks and each ID bank has 5 sub-banks. Each sub-bank has 20 ID locations. You can program up to 100 talk group IDs in each bank, so you can program up to 1,000 talk group IDs in 10 banks. When the scanner stops on a trans- mission in the Motorola, or EDACS mode, it checks to see if the ID has been stored. In the closed mode, the scanner only stops on the transmission and displays its text tag if you have stored and not locked out the ID. In the open mode, the scanner always stops on a transmission, but it displays the ID's text tag if you have stored the ID.

Storing Talk Group IDs

To store a talk group ID, press TRUNK when the scanner stops on a voice channel trans- mission or when a talk group ID is indicated in the manual mode.

The bottom line indicates where the ID was entered as % ýJ8M<ý4V44 and then changes toý% û4444. The first X in % ýJ8M<ý4V44 is the sub-bank number (0–4) in the bank. XX is the position number of the ID (00–19) in each sub-bank.

If you press TRUNK and the ID is already stored, % ýN8JýJ8M<; appears.

Note: When you try to store more than 100

talk group IDs in a bank,ap- pears. Clear some talk group IDs in order to store new ones (see “Clearing Talk Group IDs” on Page 37).

Follow these steps to manually store talk group IDs or to edit a stored ID.

1.Press PROG.

2.Press TRUNK.

3.To select the bank where you want to

store the ID, repeatedly press FUNC then 8 or 9until you reach the desired bank.

	8Wdaý&#&	ED
First ID location	?:ýDe$ý&&
	CEJ0ýded[

4.Press TRUNK repeatedly to select the sub-bank.

5.Press 8 or 9 to select the location where you desire to store the ID num- ber.

Trunking Operation 35