talk group ID decoding method to be | quencies. (See “Storing Known Fre- |
used for the bank. | quencies into Channels” on Page 15). |
â8EBýòVò +*
%ý*+ôýòò
)+0èýEFE<
,òòñUôô ôö")
òôòòòòò â8EBýòý á?ýòñ
Next channel
Notes:
•If you select *FKýKILEB<; instead of )+0, or ! , the scanner does not
trunk. Instead, *FKý KILEB<;ôý ,I<JJ
DF;< appears.
â8EBýò
*FKýKILEB<;
,I<JJýDF;<ô
•If you programmed a Motorola Type I or Hybrid system, see “Programming Fleet Maps” on Page 33.
4.Press PROG to enter the program mode.
Program | ,òòòUôô ôö") | |
òôòòòòò | ||
mode | ||
| â8EBýòý á?ýòò | |
|
|
5.Enter the desired trunking frequency using the keypad and decimal point then press ENTER to store.
,òòòUôô ôö") êììôïêëí Frequency
â8EBýòý á?ýòò
6.To enter additional trunking frequencies
as subsequent channels in the same bank, press PROG or 8to access the next open channel then enter the fre-
7. Press SCAN to start scanning.
Notes:
•If you make an error in the entry pro- cess, press CLEAR as often as needed to erase the incorrect data.
•If you enter a frequency that has already been entered, the scanner sounds an error tone and displays LGCôý= and the channel number that has been dupli- cated. If the dual entry is an error, press CLEAR and enter the correct frequency. If the dual entry is intentional, press ENTER to accept.
•You can replace any frequency by selecting the bank and channel, press- ing PROG and entering the new fre- quency.
Programming Motorola Trunking Systems (UHF-Lo)
You can program the scanner to receive transmissions in the
Note: Base and offset frequencies vary for each type of trunking system. You can get in- formation about these frequencies for the trunking system you want to scan using www.trunkscanner.com, other Internet sources, or locally published guidebooks.
32 | Trunking Operation |
