Radio Shack PRO-95 owner manual Charging Rechargeable Batteries, Using AC Power, Until Low Battery

Charging Rechargeable Batteries

Your scanner has a built-in charging circuit that lets you charge nickel-metal hydride (Ni- MH) or nickel cadmium (Ni-CD) rechargeable batteries (not supplied) while they are in the scanner. To charge rechargeable batteries, connect an appropriate AC or DC adapter to the PWR DC 9V jack. For best results we recommend RadioShack rechargeable nickel-metal hydride (NiMH) 1600mAh batteries. !

To charge batteries with a DC adapter from a DC power source, you must use a 9V, 300 mA DC adapter such as RadioShack Cat. No. 273-1810 or 273-1815 and a size B Adaptaplug™ (neither supplied). Both are available at your local RadioShack store. Make sure the adapter's voltage is set to 9V. Ô

It takes about 16 hours to recharge fully discharged 1600mAh NiMH rechargeable batteries. You can operate the scanner while recharging the rechargeable batteries, but charging takes longer.

USING AC POWER

You can power the scanner using a 9V, 300 mA AC adapter and a size B Adaptaplug (neither supplied). Both are available at your local RadioShack store.

oWARNING o

Always dispose of old batteries promptly and properly. Do not bury or burn them.

CAUTION

If you do not plan to use the scanner with batteries for a month or longer, remove the batteries. Batteries can leak chemicals that can destroy electronic parts.

Ô NOTE Ô

•The scanner can also charge Ni-Cd batteries. 600mAh batteries require 6 hours and 850mAh batteries require 8 hours to charge.

•When you charge Ni-Cd batteries, do not overcharge them. Overchar- ging shortens battery life.

•Rechargeable batteries last longer and deliver more power if you let them fully discharge once a month. To do this,

use the scanner

until Low Battery!

appears. Then fully charge the rechargeable batteries.

Preparation

11