Radio Shack TAD-759 owner manual On a Desk Top, On a Wall Plate or Wall

On a Desk Top

1.Plug one end of the supplied long modular cord into the TEL. LINE jack on the back of the base.

TEL. LINE Jack

2.Plug the cord’s other end into a modular phone line jack.

3.Plug one end of the supplied coiled handset cord into the jack at the left side of the base. Plug the other end into the handset’s jack.

4.Place the handset on the base.

5.Insert the supplied AC adapter’s barrel plug into the AC 9V jack on the back of the base.

AC 9V Jack

6.Plug the adapter into a standard AC outlet.

When you first connect power, _ _ flashes on the message counter as the TAD runs a self-test. The TAD beeps and 00 appears when the test is complete.

On a Wall Plate or Wall

Note: To mount the base directly on the wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the bottom of the base. Drill two holes 315/16 inches (100 mm) apart. Then thread a screw into each hole, letting the heads ex- tend about 3/16 inch (5 mm) from the wall.

1.Snap the supplied mounting bracket into the slots on the bottom of the TAD as shown.

Note: Be sure the keyhole slots on the bracket and the TAD are aligned in the same direction.

2.Plug one end of the supplied short modular line cord into the TEL. LINE jack on the back of the TAD.

TEL. LINE Jack

7