Radio Shack TAD-759 owner manual Setting the DAY and Time

1.Set PULSE/TONE on the back of the TAD to TONE.

2.Lift the handset and listen for a dial tone.

3.Press any number except 0.

Note: If your phone system requires that you dial an access code (9, for example) before you dial an outside number, do not dial the access code either.

If the dial tone stops, you have touch- tone service. Leave PULSE/TONE set to TONE.

If the dial tone continues, you have pulse service. Set PULSE/TONE to

PULSE.

1.Hold down SET until the TAD beeps. The TAD announces, “Sunday,” and 01 appears on the display.

Note: If necessary, adjust VOLUME on the right side of the TAD to the desired listening level.

2.To change the day, repeatedly press SKIP to move backward or REPEAT to move forward until the TAD announces the desired day.

SETTING THE DAY AND TIME

The TAD-759 records the day and time each memo and message is recorded. Follow these steps to set the day and time.

Note: If you do not complete each step within 8 seconds, the TAD sounds three beeps and exits. Start again at Step 1.

3.Press STOP. The TAD shows the cur- rently set hour and announces “AM” or “PM.”

4.To change the hour, repeatedly press SKIP or REPEAT.

9