This is a table showing the signal available at each pin of CON1, the access number for which the pin is accessed and changed, the group number for disabling and enabling, description, name, and range of output. “?” indicates a variable number.
Pin # | Name | Device # | Description | Access # | Range |
|
1 | VoutD | 15 | Level 3 | *53??? | ||
2 | VoutA | 12 | Level 0 | *50??? | ||
3 | VoutC | 14 | Level 2 | *52??? | ||
4 | VoutB | 13 | Level 1 | *51??? | ||
5 | +5V | - | V source | - | 5V | |
6 | +12V | - | V source | - | 12V | |
7 | GND | - | Common | - | 0V | |
8 | T2 | 18 | Timer 2 | *T2??*??* | 10mS to 40H | |
9 | T0 | 16 | Timer 0 | *T0??*??* | 10mS to 40H | |
10 | T1 | 17 | Timer 1 | *T1??*??* | 10mS to 40H | |
11 | W1 | 9 | Pot 1 Wiper | *21??? | ||
12 | H1 | 9 | Pot 1 High | Not adjusted | ||
13 | L1 | 9 | Pot 1 Low | Not adjusted | ||
14 | L0 | 8 | Pot 0 Low | Not adjusted | ||
15 | H0 | 8 | Pot 0 High | Not adjusted | ||
16 | W0 | 8 | Pot 0 Wiper | *20??? | ||
17 | GND | - | Common | - | 0V | |
18 | 1,7 | 1 | Output | *617? | 5V on off | |
19 | 0,7 | 0 | Output | *607? | 5V on off | |
20 | 1,6 | 1 | Output | *616? | 5V on off | |
21 | 0,6 | 0 | Output | *606? | 5V on off | |
22 | 1,5 | 1 | Output | *615? | 5V on off | |
23 | 0,5 | 0 | Output | *605? | 5V on off | |
24 | 1,4 | 1 | Output | *614? | 5V on off | |
25 | 0,4 | 0 | Output | *604? | 5V on off | |
26 | 1,3 | 1 | Output | *613? | 5V on off | |
27 | 0,3 | 0 | Output | *603? | 5V on off | |
28 | 1,2 | 1 | Output | *612? | 5V on off | |
29 | 0,2 | 0 | Output | *602? | 5V on off | |
30 | 1,1 | 1 | Output | *611? | 5V on off | |
31 | 0,1 | 0 | Output | *601? | 5V on off | |
32 | 1,0 | 1 | Output | *610? | 5V on off | |
33 | Tone | - | Tone out | *600? | Confirm Out | |
34 | GND | - | Common | - | 0V | |
Note: Pin 33 can be accessed as an output, but its value will change every time a code is received and a tone is sent, therefore it is not recommended to be used as an output other than for generating tones.
