GB/IE
Make 10 complete (360°) turns clockwise. (This means turning and removing the levelling tool 20 times).
The front feet and rear rollers can be adjusted to level the cooker. To adjust the height of the rear of the cooker use the levelling tool supplied to turn the adjusting nuts at the front bottom corners of the cooker. To set the front feet turn the bases to raise or lower.
Fit the Handles
Door handles
Remove the 4mm Allen screws from the doors with the hexagon key tool. Use the screws to fit the door handles.
The handles should be above the fixings.
Make sure you lower BOTH REAR ROLLERS. There are two adjusting nuts, one for each roller, at both the front bottom corners of the cooker. Open the grill door and the Holding oven door. Grip under the facia panel and lift the front of the cooker.
Carefully push the cooker backwards close to its final position leaving just enough space to get behind it.
Take care not to damage the power cable.
Do not use the door handles or control knobs to manoeuvre the cooker. Remove the pack base tray.
Levelling
You are recommended to use a spirit level on a shelf in one of the ovens to check for level.
Place the cooker in its intended position taking care not to twist it within the gap between the kitchen units as damage may occur to the cooker or the units.
Handrail
Remove the 4mm Allen screws from the top corners of the facia and fix the front handrail in position.
Electrical Connection
This appliance must be installed by a qualified electrician to comply with the relevant regulations and also the local electricity supply company requirements.
Make sure that the mains characteristics (voltage, nominal, power, etc.) match the ratings indicated on the data plate affixed to the lower right hand cooker upright (remove storage drawer). The cooker is preset for a
WARNING: THIS APPLIANCE MUST BE EARTHED
The appliance must be connected to an efficient earthing circuit. If the electricity network is not equipped with an earth connection, then it must be
24
