Once the linings are removed, the oven enamel interior can be cleaned.
Moving your cooker
Switch off the electricity supply.
The cooker is heavy, two people may be required to move it. The cooker is fitted with one roller at the front and two at the back. There are also two screw down levelling feet at the front.
The front roller, designed for moving the cooker can be wound down. The levelling tool that controls this roller is in the storage drawer compartment.
Remove the storage drawer (by pulling it right out and lifting it up slightly) and you should see the levelling tool.
Your installer may not have left the levelling tool in place. If not, locate it as shown. If you cannot
find the levelling tool, contact your installer. See the Installation section of these instructions where your installer should have written their contact details.
Open the grill door and right hand oven door so that you can get a good grip on the bottom of the fascia panel as you move the oven.
Do not move the oven by pulling the hand rail, door handles or knobs.
Move the oven a bit at a time, checking behind it to make sure the gas hose is not caught. Make sure both electricity and gas cables have suffi cient slack to move the cooker forward as you go along.
If a stability chain is fitted, release it as you ease the cooker out.
When you replace the cooker, wind it down off the rollers by turning the levelling tool anti- clockwise. This is important. It will stop the cooker moving accidentally, while in use.
When you replace the cooker, wind it down off the rollers by turning the levelling tool anti- clockwise. This is important. It will stop the cooker moving accidentally, while in use.
Turn the levelling tool clockwise, two full (180°) turns. It will be stiff. The front of the oven will rise slightly as the roller drops down.
16
