Rangemaster U109976 - 02 Completing the Move, Repositioning the Cooker following Connection, 5, 8

Fig.7-5

ArtNo.010-0002 Rear roller nut

Fig.7- 6

ArtNo.010-0010 Lowering the rear rollers (90)

x10

Fig.7-7

ArtNo.010-0009 Pushing the cooker

Fig.7-8

ArtNo.010-0004 Moving the cooker

Lower the Two Rear Rollers

First fit the levelling tool on the hexagonal adjusting nut (Fig.7-5).

Make 10 complete (360º) turns clockwise (Fig.7-6). (This means turning and removing the levelling tool 20 times.)

Make sure you lower BOTH REAR ROLLERS. There are two adjusting nuts, one for each roller, at both the front bottom corners of the cooker.

Completing the Move

Unfold the rear edge of the pack base tray. Open the grill door and right-hand oven door so that you can get a good grip on the bottom of the fascia panel as you move the cooker.

Grip under the fascia panel and lift the front of the cooker slightly (Fig.7-7).

Carefully push the cooker backwards off the pack base. Remove the pack base tray. Position the cooker close to its final position, leaving just enough space to get behind it.

Do not use the door handles or control knobs to manoeuvre the cooker.

Repositioning the Cooker following Connection

If you need to move the cooker once it has been connected, make sure it is switched off at the supply switch before gripping under the fascia panel and lifting the front of the cooker slightly (Fig.7-8). Check behind the cooker to ensure that the electricity cable is not caught. As you progress, always ensure that the cable has sufficient slack to allow the cooker to move.

If a stability chain is fitted, release it as you ease the cooker out. Do not forget to refit it when you replace the cooker.

When you replace the cooker, check behind it again once more to ensure that the electricity cable is not caught or trapped.

Levelling

It is recommended that you use a spirit level on a shelf in one of the ovens to check for level.

Place the cooker in its intended position. Take care not to twist it within the gap between the kitchen units, as otherwise, damage may occur to the cooker or units.

The front feet and rear rollers can be adjusted to level the cooker. To adjust the height of the rear of the cooker, use the levelling tool supplied to turn the roller adjusting nuts at the front bottom corners of the cooker. To raise or lower the feet, simply turn the disks that are fitted onto them.

Fitting the Splashback (optional)

The splashback fits the back of the cooker. It is secured using four screws (2 at each end) in the rear edge of the flue grille. Remove the outer two screws and then loosen the inner pair.

20