Raypak 302-902 Hi Delta Filter Box Kit, Thiskitincludes, Model, Partnumber, Heater as shipped

HI DELTA FILTER BOX KIT

NOTICE:

These instructions are intended for use by qualified personnel specifically trained and experienced in the installation of this type of heating equipment and related system components. Installation and service personnel are required to be licensed in some states. Persons not qualified shall not attempt repairs according to these instructions.

Vent collar	Air intake collar
THISKITINCLUDES:	MODEL	PARTNUMBER
1- Filter box	992-1532	#007101- 8”
1- Decal (attached)	1802-2342	#007102- 10”
6- Screws
1- Instructions
Heater as shipped

HI DELTA FILTER BOX INSTRUCTIONS

NOTICE:

These instructions pertain only to units installed outdoors only. All Hi Delta units are shipped with the air intake collar mounted temporarily on the top of the heater for shipping purposes. If this is to be installed outdoors, the air intake collar and filter box must be relocated to the back of the unit to prevent recirculation of flue products.

1. Turn off the gas and power to the unit.	Air intake	Vent
	collar	collar

2.Remove the four screws holding the air intake collar on the top of the unit.

3.	Remove the four screws holding the cover plate. See Fig. 1.	Cover
4.	Remove the white gasket paper off the air intake collar.	plate
5.	Align the four holes of the air intake collar over the four
	holes on the opening on the back of the heater.
6.	Mount air intake collar on back of the heater using four		Fig. 1 Back of heater
	screws.
7.	Remove the white gasket paper off the cover plate.
8.	Align the four holes of the cover plate over the opening
	on the top of the heater.		Filter
9.	Mount the cover plate using four screws.	Align filter	warning
		box to edges

10.Hold the box over the air intake filter warning decal facing outward and align the top and side edges as shown in Fig. 2.

Fig. 2 Back of heater

41