![](/images/new-backgrounds/1116239/1162399x1.webp)
CAUTION: Propane gas is heavier than air and will settle on the ground. Since propane can accumulate in confined areas, extra care should be exercised when lighting propane heaters.
OPERATING INSTRUCTIONS AND
AUTOMATICALLY LIGHTED PILOTS
ELECTRONIC IGNITIONS SYSTEMS
A. | This appliance is equipped with an ignition |
| *If you cannot reach your gas supplier, call the fire | |||
| device which automatically lights the pilot. Do |
| department. | |||
| not try to light the pilot by hand. |
|
|
|
| |
B. | BEFORE OPERATING, smell all around the |
| C. Use only your hand to push in or turn the gas | |||
|
| control knob. Never use tools. If the knob will | ||||
| appliance area for gas. Be sure to smell next |
|
| not push in or turn by hand, don't try to repair | ||
| to the floor because some gas is heavier than |
|
| it; call a qualified service technician. Force or | ||
| air and will settle on the floor. |
|
| attempted repair may result in fire or explo- | ||
| WHAT TO DO IF YOU SMELL GAS: |
|
| sion. | ||
|
|
|
|
| ||
| *Do not try to light any appliance. |
| D. Do not use this appliance if any part has been | |||
| *Do not touch any electric switch; do not use |
|
| underwater. Immediately call a qualified serv- | ||
| any phone in your building |
|
| ice technician to inspect the appliance and to | ||
| *Immediately call your gas supplier from a |
|
| replace any part of the control system and any | ||
| neighbor's phone. Follow the gas supplier's |
|
| gas control which has been underwater. | ||
| instructions. |
|
|
|
| |
|
| OPERATING INSTRUCTIONS |
| |||
|
|
| ||||
| 1. STOP! Read the safety information above. | GAS CONTROL KNOB SHOWN IN "ON" POSITION | ||||
| 2. Set the thermostat to the lowest setting. |
|
|
|
| |
| 3. Turn off all electric power to the appliance. |
|
|
| HONEYWELL | |
| 4. This appliance is equipped with an ignition | GAS |
|
| ||
| device which automatically lights the pilot. |
|
| VR 8300 GAS | ||
| INLET |
| ||||
|
| VALVE IID | ||||
| Do not try to light the pilot by hand. |
|
|
| ||
|
|
|
|
|
5.Remove heater door panel.
6.For Honeywell Valve: Turn gas control
knob clockwise to "Off".
For Robertshaw valve: Turn gas control
knob clockwise |
|
| to "Off".(Models | ROBERTSHAW 7000 | |
n and | move gas control | GAS VALVE IID | |||
lever |
| to "Off" | MODEL | ||
| |||||
position. (Model 185) |
|
|
| ||
|
|
|
7.Wait 5 minutes to clear out any gas. If you then smell gas STOP! Follow "B" in the safety information previously stated. If you
| don't smell gas, go to the next step. |
| Fig. # 8080.0 | ||
|
|
| |||
8. | Turn gas control knob | GAS CONTROL |
| ||
|
| to "On". (Honeywell VR 8300 and | LEVER SHOWN |
| |
|
|
| |||
|
|
| IN "OFF" |
| |
| Robertshaw 7000) |
| |||
| POSITION | ROBERTSHAW | |||
9. | Replace heater door panel. | ||||
| |||||
| 7200 GAS VALVE | ||||
10. | Turn on all electric power to the appliance. |
| |||
| IID MODEL 185 | ||||
11. | Set thermostat to desired setting. | GAS |
| ||
12. | If the appliance will not operate, follow the |
| |||
INLET |
| ||||
| instructions "To Turn Off Gas To Appliance" |
| |||
|
|
|
and call your service technician or gas | Fig. # 8934.1 | ||
supplier. | |||
| |||
| TO TURN OFF GAS TO APPLIANCE |
| |
|
|
1.Set the thermostat at the lowest setting.
2.Turn off all the electric power to the appliance if service is to be performed.
3.Remove heater door panel.
4.For Honeywell VR 8300 and Robertshaw 7000 gas valve.
Turn gas control knob clockwise
to "Off". Make sure knob rest against stop.
For Robertshaw 7200 gas valve.
Push in and move gas control lever counter-
clockwise to "Off" position.
5. Replace heater door panel.
5