RCA 12L500TD manual Complete the Initial Setup, Complete Auto Channel Search

Chapter 1: Connections & Setup

Complete the Initial Setup

The menu systems in your TV/DVD allow the unit’s features to work properly. You’ll need to set a few

important menu items the first time you turn on your TV/DVD.

MAIN M E NU

SELECT VIDEO

S E T P IC TU R E

AUTO - PROGRAM

ANTENNA INPUT

ANTENNA

AIR

STD

IRC

HRC

Tip

You can also program the available channels by pressing the AUTO PROGRAM button on the remote. You still need to set the ANTENNA INPUT in the menu for the type of signal you have first, however.

Complete Auto Channel Search

This part of the setup allows the TV to search for all channels viewable through your antenna or cable TV system. This is sometimes called auto programming.

1.Make sure the remote is in the TV mode by pressing the TV button.

2.Press MENU (the Main menu appears).

3.Press the down arrow button until ANTENNA INPUT is highlighted, and press ENTER (the ANTENNA menu appears).

4.Press the down arrow button to highlight AIR (for an off-air antenna), STD (for standard cable), IRC, or HRC depending on the type of signal you have. Then press

ENTER.

5.Press MENU again (the Main menu appears).

6.Press the down arrow button until AUTO-PROGRAMis highlighted, and press ENTER to begin the auto channel search. This may take several seconds.

Once the search is complete, you can begin watching TV. To add or delete any channels, go to page 33.

Chapter 1 13