Agilent Technologies E4406A manual Changing the Measurement Setup, Table

			Making Measurements
		Making the Channel Power Measurement
	Changing the Measurement Setup
	The next table shows the factory default settings for channel power
	measurements.
	Parameters under the Advanced key seldom need to be changed. Any
NOTE
	changes from the factory default values may result in invalid
	measurement data.
Table 4-5	Channel Power Measurement Defaults
	Measurement Parameter		Factory Default Condition
	Meas Setup:
	Avg Number		20; On
	Avg Mode		Repeat
	Integ BWa		1.23000 MHz
	Chan Power Spana		2.00000 MHz
	Advanced
	Sweep Time		68.0 ∝s; Auto
	Data Points		512; Auto
	Res BW (grayed out)		27.857 kHz (grayed out)
	Trig Source		Free Run (Immediate)
	a. The Integ BW setting proportionally changes the Chan Power
	Span setting up to 10 MHz.

Make sure the Channel Power measurement is selected under the MEASURE menu. The Meas Setup key accesses the menu which allows you to modify the average number and average mode for this measurement.

The following parameters can be changed according to your measurement requirement:

•Integ BW - Allows you to specify the integration bandwidth in which the power is measured. The range is 1.000 kHz to 10.0000 MHz with 1 Hz resolution. Since Integ BW is coupled to Chan Power Span in the factory default condition, if you change the integration bandwidth setting, the channel power span setting changes by a proportional amount, 1.626 times the integration bandwidth, until a limit value is reached.

Chapter 4 133