Agilent Technologies E4406A manual Changing the Measurement Setup, Table

Making Measurements

Making the Waveform (Time Domain) Measurement

Changing the Measurement Setup

This table shows the factory default settings for waveform (time domain) measurements.

Table 4-2	Waveform (Time Domain) Measurement Defaults
	Measurement Parameter	Factory Default Condition
	View/Trace	RF Envelope
	Sweep Time	2.000 ms
	Res BW	100.000 kHz
	Averaging:
	Avg Number	10; Off
	Avg Mode	Exp
	Avg Type	Pwr Avg (RMS)
	Trig Source	Free Run (Immediate)
	Signal Envelope View:	200.0 ∝s
	SPAN X Scale - Scale/Div
	AMPLITUDE Y Scale - Scale/Div	10.00 dB
	I/Q Waveform View:	200.0 ∝s
	SPAN X Scale -Scale/Div
	AMPLITUDE Y Scale - Scale/Div	100.0 mV
	I/Q Polar View:
	I/Q Scale/Div	100.0 mV
	I or Q Origin	0.00 V
	Advanced
	Pre-ADC BPF	Off
	RBW Filter	Gaussian
	ADC Range	Auto
	Data Packing	Auto
	ADC Dither	Off
	Decimation	Off
	Parameters that are under the Advanced key seldom need to be changed.
NOTE
	Any changes from the default values may result in invalid
	measurement data.

Make sure the Waveform (Time Domain) measurement is selected under the MEASURE menu. Press the Meas Setup key to access a menu which allows you to modify the averaging, and trigger source for this measurement (as described in the “Measurement Setup” section).

Chapter 4 113