RCA 25420 Other Information, Unit beeps, Memory Dialing doesn’t work, Caller ID Error Message

Models: 25420

1 40
Download 40 pages 22.53 Kb
Page 35
Image 35
Unit beeps

Other Information

The cordless handset may be out of range of the base. Move closer to the base.

Charge the battery.

Unit beeps

Clean charging contacts on cordless handset and charge cradle with a soft cloth or an eraser.

See solutions for “No dial tone” on previous page.

Replace the battery.

Memory Dialing doesn’t work

Did you program the memory location keys correctly?

Did you follow proper dialing sequence?

Unit locks up and no communication between the base and cordless handset

Unplug the AC power adaptor from the wall outlet and the back of the base, and remove the backup batteries from the bottom of base (if previously installed). Remove the handset battery. Wait for 30 seconds and plug the power adaptor back into the base and wall out, and re-install batteries in the base unit. Reconnect the handset battery and charge for 14 hours.

Caller ID Solutions

No Display

Is battery fully charged? Try replacing the battery.

Make sure that the unit is connected to a non-switched electrical outlet. Disconnect the AC power supply from the base and reconnect it.

Caller ID Error Message

• The unit displays this message if it detects anything other than valid Caller ID information during the silent period after the first ring. This message indicates the presence of noise on the line.

No Caller ID

In order to receive Caller ID information, you must subscribe to the standard name/ number Caller ID service from your local telephone company.

Battery Solutions

If you experience any of the following problems, even after fully recharging the battery, you may need to replace the battery pack:

Short talk time

Poor sound quality

Limited range

35

Page 35
Image 35
RCA 25420 manual Other Information, Unit beeps, Memory Dialing doesn’t work, Caller ID Solutions No Display, No Caller ID