DRC8335_EN(verB) 7/23/07 3:37 PM Page 30
More information
VCR problems
No picture or snowy picture
¥Turn on the TV.
¥Make sure your unit is connected properly, and tune your TV to the Video Input Channel that corresponds to the jacks you used to connect the TV to the unit.
¥If you connected a satellite receiver or a cable box, make sure it is turned on.
¥Some snow or streaks are normal during search, stop action, frame advance, and
¥Adjust the tracking by pressing the TRK+/Ð buttons during tape playback.
¥The tape may be worn out or of poor quality.
Tape will not play
¥Make sure your unit is connected properly, and tune your TV to the Video Input Channel that corresponds to the jacks you used to connect the TV to the unit.
¥Try ejecting the tape and reinserting it.
¥Make sure the tape is not broken.
¥Make sure the unit is not in pause mode. Press PAUSE or PLAY to return to normal playback.
Time counter disappears during searching
¥This is normal if the tape reaches a section where there is nothing recorded on it.
¥Try ejecting the tape and reinserting it.
Tape will not record
¥Make sure there is a recordable tape in the unit.
¥Make sure the tapeÕs safety tab is intact and has not been removed.
Timer recordings problems
¥Make sure the clock is set and the time is correct.
¥Make sure you set up the timer recording correctly.
¥If you are recording from a satellite receiver or cable box, make sure they are turned on and tuned to the desired channel when it is time for the recording to start. Also, if you used audio/video or
Remote control problems
Remote will not work
¥Insert new batteries in the remote.
¥Operate the remote control at a distance of no more than 20 feet.
¥Remove any obstacles between the remote and the unit or other component. If your unit is in an entertainment cabinet, the glass doors might obstruct the remote control from operating the DVD recorder. Open the doors.
Maintenance
For safety reasons, when cleaning the cabinet be sure to disconnect the AC power cord from the AC outlet.
¥Do not use benzene, thinner, or other solvents for cleaning.
¥Wipe the cabinet with a soft cloth.
Formation of Condensation
¥Due to sharp changes in temperature and humidity, condensation may form if warm air comes in contact with any cold parts inside the player.
¥When condensation forms inside the player, the player may not operate correctly. If this occurs, leave the player at room temperature until the inside of the player becomes dry and operational.
¥If condensation forms on a disc, wipe the disc with a soft, dry cloth by moving the cloth from the center hole toward the outer edge.
Handling Discs
¥Do not touch the discÕs signal surfaces. Hold by the edges or by one edge and the hole in the center.
¥Do not affix labels or adhesive tape to label surfaces. DonÕt scratch or damage the label.
¥Do not use damaged (cracked or warped) discs.
Note
FCC Regulations state that unauthorized changes or modifications to this equipment may void the userÕs authority to operate it.
This DVD Recorder is designed and manufactured to respond to the Region Management Information. If the Region number of a DVD disc does not correspond to the Region number of this DVD Recorder this DVD Recorder cannot play the disc. The Region number for this DVD Recorder is Region No 1.
This device is protected by U.S.patent numbers 4,631,603 and 4,577,216 and 4,819,098 and other intellectual property rights. The use of MacrovisionÕs copy protection technology in the device must be authorized by Macrovision and is intended for home and other limited
Dolby and the
Dolby Laboratories.
The descriptions and characteristics given in this document are given as a general indication and not as a guarantee.
In order to provide the highest quality product possible, we reserve the right to make any improvement or modification without prior notice. The English version serves as the final reference on all products and operational details should any discrepancies arise in other languages.
28
