Using Your RCA 25450 Phone System

Using Your RCA 25450 Phone System

Your RCA 25450 Cordless Handset comes ready to use unless it was purchased sepa- rately from the Base Unit. If purchased separately, it must be registered before use. See “Registering Handsets” in this manual. This section details the basic operation of the Cordless Handset, including instructions on making, receiving and ending a call, call waiting, switching between audio modes, putting a call on hold, muting, transferring a call, and using the intercom.

Making a Call

Press and hold the End button to turn on the Cordless Handset. You will hear a confirmation tone and see the display when the Handset is on. Calls can be made by pressing the Talk or Speaker buttons or plugging in a headset.

Refer to Auto or Manual Line Selection in this User’s Guide for instructions on set- ting your Cordless Handset to the Auto or Manual Line Selection Mode.

Auto Line-Selection Dial

The Auto Line-Selection Dial function allows the user to dial a phone number with- out first choosing a line. An available line is automatically selected.

1. Press the Talk or Speaker button.

NOTE: To cancel dialing at any time, press the End button.

2.The display will show “Press REDIAL or dial number” or the dialing prefix if it is enabled via the phone setting menu.

3.Press the soft button to redial the last number called, or enter the phone number using the keypad (0–9, *, #).

4.If the Cordless Handset can not establish a connection to the Base Unit after 15 seconds, it will show “No connection”. If all usable phone lines are not available, it will show “No line is available”. If there are usable phone lines available but all system resources are in use, the display will show “System busy”.

22

Page 22
Image 22
RCA H5450 manual Using Your RCA 25450 Phone System, Making a Call, Auto Line-Selection Dial