RCA 253 Series, HT60903BD, HT35713BD manual Troubleshooting Checks, Here’s What to Try, continued

Troubleshooting Checks (continued)

Trouble Here’s What to Try

No Video from VCR or laserdisc player

CanÕt get TV channels

CanÕt record from laserdisc player

¥Make sure TV is in the correct input. If the TV does not go to the correct input when the VCR1, VCR2•LD, or DSS•CABLE button on the remote are pressed, refer to the Test the System section of the Installation and Hookup Guide for proper programming of the components.

¥Make sure all cables are connected as shown in the Installation and Hookup Guide.

¥After pressing the TV button on the remote, you must enter the channel you wish to watch or press Channel up or down on the remote.

¥The system is not configured to record from the laserdisc player onto the VCR. To record from the laserdisc player you must remove the two-wire cable from the TV that comes from the laserdisc player. This then gets connected to R & L inputs on the back of the VCR. An additional video cable will then need to be connected from the Video Out 2 of the laserdisc player to the Video Input of the VCR. The VCR must then be put into the L1 input mode. This can be done by pressing the VCR1 button on the remote and then the

INPUT•SEEK button.

VCR or laserdisc player wonÕt turn on the first time you press the VCR1 or VCR2•LD buttons on the remote

¥Make sure the power cords of all the components are connected as shown in the Installation and Hookup Guide.

32