Install Snowthrower
CONNECT TO HITCH
1.Position the snowthrower in front of the hitch. Insert the hitch pin (A, Figure 24) through the snowthrower and hitch on both sides of the snowthrower. Secure with a hair pin clip (B). Use the back set of hitch holes (see inset).
NOTE: The hitch pin (A) goes in between the belt, NOT below or above it.
INSTALL LIFT ROD
2.Attach the front of the lift rod assembly (A, Figure 25) to the lift arm (C). Secure with a hair pin clip (B).
3.Connect the rear of the lift rod assembly (A, Figure 26) to the tractor lift arm extension (C). Secure with a hair pin clip (B).
NOTE: If necessary, perform the lift rod adjustments found in the Troubleshooting, Adjustments, & Repair section.
NOTE: See Lift Lever Kit Installation Instructions for lift rod installation.
Initial Setup & Assembly
B |
A |
Figure 24. Install Snowthrower
A.Hitch Pin
B.Hair Pin Clip
B |
A |
C |
Figure 25. Lift Rod - Front
A.Lift Rod Assembly
B.Hair Pin Clip
C.Lift Arm
| A |
C | B |
|
Figure 26. Lift Rod - Front
A.Lift Rod Assembly
B.Hair Pin Clip
C.Lift Arm
19
