Snapper 1724089, 1695099, 1694238, 1694874 manual Mounting Remote Deflector Control

Mounting Remote Deflector Control

Line Template Up with Edge of Plastic Dashboard

Mark and Drill One 9/32” Hole Mount Bracket and align with Line Mark and Drill One 9/32” Hole

Figure 37. Template Location

MOUNTING REMOTE DEFLECTOR CONTROL

NOTE: Read through instructions before beginning.

1.Open the hood.

2.Cut out the template and place it on the lower left cor- ner of the dashboard as shown above.

3.Mark and drill one 9/32” hole using the template to locate the holes.

4.Mount the remote deflector mounting bracket (E, Figure 38) control to the dashboard using upper hole.

5.Align center of lower hole to dashed line on template and mark. Remove the remote deflector mounting bracket (E). Drill one 9/32” hole using the marked location.

6.Mount the remote deflector mounting bracket (E) con- trol to the dashboard. Secure using two 1/4-20 x 7/8” capscrews (A) through the bracket (E) and dash- board.

7.Secure with 1/4 x 1-1/4 flatwashers (B), lockwashers (C), and nuts (D) on the BACKSIDE of the dash- board.

DO NOT OVER-TORQUE. Over-torquing may crack the dashboard.

	E
D	A
C	B

Figure 38. Mount Control Bracket - Current Models

A. 1/4-20 x 7/8 Capscrews	D. 1/4-20 Nuts
B. 1/4 x 1-1/4 Flatwashers	E. Mounting Bracket
C. 1/4 Lockwashers

26