Removing & Installing the Snowthrower
8.Remove the hitch pin and clip (D, Figure 33) from the snowthrower and remove the snowthrower. Reinstall all pins and clips to prevent loss.
9.Remove the clevis pin and hair pin (G, Figure 33 RH manual lift models) frame mounted bracket. Reinstall all pins and clips to prevent loss.
10.Return the lift bar (B, Figure 14, manual lift models) or lock plate (D, Figure 15, hydraulic lift models) to lawn mowing position.
Normal Installation
1.Install the
2.Place the snowthrower in front of the tractor and secure to the hitch using the hitch pin and clip (D, Figure 33).
3.Route the drive belt as shown in Figure 35. Note that the back of the belt rides in the
4.With the snowthrower drive belt installed, trunnion (A, Figure 34) should be between the marks (G) on spring tension bracket (B) for correct belt tension. Turn belt tension handle (C) to move trunnion forward or rearward until between marks.
5.Connect the rear of the lift rod (B, Figure 33) to the lift arm extension. Use a hair pin clip (C) to secure the front of the lift rod to the snowthrower.
6.Connect the rotator motor plug (A). Route the har- ness along the deflector control cable as shown.
7.Install the remote chute deflector control to the mounting plate and secure with a clevis pin and clip (E, Figure 33).
8.Fully raise and support the snowthrower with wood blocks. Manual Lift Models: Install the lift assist spring and anchor (F, Figure 33).
9.Install lift lever assembly (H, Figure 33 RH lift lever models) and secure with clevis pins and hair pins (G)
10.Place the lift bar (B, Figure 14, manual lift models) or lock plate (D, Figure 15, hydraulic lift models) in snowthrowing position.
CAUTION
Spring under tension. Keep clear of pinch points.
B | A | A | G | C |
| G | E | ||
|
|
|
| |
| D |
|
| F |
Figure 34. Adjusting Belt Tension
A. Trunnion | E. Idler Pulley |
B. Spring Tension Bracket | F. Pivot Bracket |
C. Handle | G. Tension Marks |
D. Capscrew |
|
B |
C |
B |
A |
D |
E |
Figure 35. Belt Routing
A.Snowthrower Pulley (V-pulley)
B.Back-side Idler Pulley
C.Electric Clutch Pulley (V-pulley)
D.Idler Pulley (V-pulley)
E.Hitch Pin
23
