Connections & Setup
Things to Consider Before You Connect
Protect Against Power Surges
•Connect all devices before you plug any of their power cords into the wall outlet.
•Turn off the TV and/or device before you connect or disconnect any cables.
•Make sure all antennas and cables are properly grounded. Refer to the Important Safety Instructions on page 1.
Protect Devices from Overheating
•Don’t block ventilation holes on any of the devices. Arrange the devices so that air can circulate freely.
•Don’t stack devices.
•If you place devices in a stand, make sure you allow adequate ventilation.
•If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won’t flow around other devices.
Position Cables Properly to Avoid Audio Interference
•Insert each cable firmly into the designated jack.
•If you place devices above the TV, route all cables down the side of the back of the TV instead of straight down the middle of the TV.
•If your antenna uses
Use Indirect Light
Don’t place the TV where sunlight or room lighting will be directed toward the screen. Use soft or indirect lighting.
Cables Needed to Connect Devices to Your TV
The pictures below show the cables needed for the connections represented in this book. The next two pages explain the inputs and outputs your HDTV offers for connecting devices.
Audio/Video | Coaxial cable | Component Video | ||
cables |
|
| (Y•Pb•Pr) cables |
|
Chapter 1 |
