Other

If the component you want to control does turn off:

1.Press and release REVERSE, then wait 2 seconds. Repeat this step until the device turns back ON.

2.To finish, press and hold STOP until the red light on the remote turns off.

Direct Entry

1.Turn on the component to be programmed.

2.Look up the brand and code number(s) l_0rthe component on the code list in tiffs section.

3.Point the DVD Player's remote at the component.

4.Press and hold the component button on the remote you want to program.

5.Enter the code from the Remote Control code list on the following pages.

6.Release the component button, and then press ON-OFF to see if the component responds to the command. If it doesn't, try pressing the component button and then ON • OFF again.

7.If you get no response, repeat these steps using the next code listed for your brand, until the component responds to the remote commands.

Information

Important Tips!

You must continue pressing

the component button while you enter the code.

Let's say you have a Zenith

T_ To program the universal remote to operate the TV you would:

Press and hold the TV button

while you enter the first code listed for Zenith in the TV Codes column.

Release the TV button. Press

ON.OFF to see if the 73/

responds, if it doesn't, follow the same steps, but enter the second code instead of the first.

Operate Components after Programming the Remote

Because this universal remote can control several different components (TV, DVD, VCR, satellite receiver, etc.) it uses operational modes triggered by the component buttons. For example if you want the remote to control the TV, you would press the TV button to put the remote into TV mode before you could control the TV.

1.Press the appropriate component button (DVD, TV, VCR1, VCR2, SAT-CABLE, or AUX) to set the remote to Control the component.

2.Press ON.OFF to turn the component ON or OFF.

3.Use the remote buttons that apply to that component.

/Vote: This remote may not be compatible with all brands and models of components.

Chapter 7

95

Page 97
Image 97
RCA RC5227P user manual Other, Information, Operate Components after Programming the Remote, Direct Entry