Connections Ik Setup
Things to Consider Before You Connect
Protect Against Power Surges
•Connect all components before you plug any of their power cords into the wall outlet.
•Turn off the TV and/or components before you connect or disconnect any cables.
•Make sure all antennas and cables are properly grounded. Refer to the Important Safeguards sheet packed with your DVD player.
Protect Components from Overheating
•Don't block ventilation holes on any of the components. Arrange the components so that air can circulate freely.
•Don't stack components.
•When you place components in a stand, make sure you allow adequate ventilation.
•If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won't flow around other components.
Position Cables Properly to Avoid Audio Interference
•Insert each cable firmly into the designated jack.
•If you place components above the TV, route all cables down the side of the back of the TV instead of straight down the middle of the back of the TV.
•If your antenna uses
Connection Pictures
Audio/video cables are usually bundled together. For better visibility, the connection pictures in this book show each cable separately (audio left, audio right, and video).
Types of Discs Your DVD Player will Play
•DVD video discs - DVD video discs contain high quality picture and sound content.
•Audio discs - Audio CDs contain musical or sound content only.
•Video CD discs - Like DVD video discs, Video CDs contain picture and sound content. The difference is the amount of information that can be stored on the disc.
•
•
_rN.,,_oVIDEOCD
6 | Chapter 1 |
